Ehrgeiz BABYBEAM4, Руководство пользователя

Страница: 4 / 24

Introduction

Safety Instructions
2
Make sure that the area below the installation place is cordoned off when
rigging, de-rigging or servicing the fixture.
If suspending from a rigging structure, fasten the fixture to a rigging clamp
with an M10 bolt screwed into the threaded hole in the center of the base of
the fixture. The bolt must be screwed at 20-25mm into the fixture. If the
fixture is suspended by any other method, an M10 bolt must be screwed into
this hole so that it is 20-25mm into the fixture.
Make sure all fixtures are operated and installed by qualified personnel with
the relevant national certifications.
Install as described in this manual a secondary attachment such as a safety
wire that is approved by an official body. The safety wire must comply with
EN 60598-2-17 Section 17.6.6 and be capable of bearing a static suspended
load ten times the weight of the fixture.
Positioning:
The fixture must be positioned at least 0.2m minimum distance to illuminate
objects.
Keep all inflammable materials at least 0.2m from this fixture.
Allow to place the fixture on an inflammable surface.
The maximum ambient temperature of 45°C may not be exceeded.
The exterior of this fixture can reach a very high temperature during
operation. Avoid contact by persons and materials.
Maintenance:
This fixture is for professional use only. It is not for household use.
Always unplug the mains for any maintenance.
Risk of eye injury:
Do not stare directly into the light when it is switch on. Do not look at LEDs
with magnifying glasses, telescopes, binoculars, or similar optical
instruments that may concentrate the light output.