FENDER FLARES INSTALLATION INSTRUCTIONS
FF935
24/05/19
Page 2 of 7
On the inside of the fender flare remove approximately
25mm of the protective liner from the double sided tape
locations. Fold the liner over and secure with masking tape
to the outside of the bumper flare.
Fit the fender flare to the vehicle in the uppermost vertical
position, before final fixings and tape application is com-
pleted as shown.
4
5
MUD FLAP
1
2
Remove the mud flaps by removing the (7) scrivets from
inside the wheel arch as shown.
Wash the areas of contact on the vehicle and wipe dry.
Wipe the fender where the flare will contact, using provided
Alcohol wipes.
3
(x7)
INSTALL
Hold the splash guard inwards and push the supplied (3x) 8.5
Speed Nuts onto the front guard into the 3 hole positions as
shown. Fold the plastic Tab inwards over the fender and secure
with one Phillips head screw.
SPEED NUT
FENDER
7
8
10
+
6
Reattach the wheel arch liner with two factory scrivets.
