INSTALLATION ON THE VEHICLE
15
The technical materials and information contained in this document are strictly confidential and the exclusive property of Advanced Microwave Engineering s.r.l.
These materials and information are intended solely for the purpose designated and may not be used otherwise.
It is not permitted to disclose or reproduce them in whole or in part without express written permission.
8.2
POSITIONING THE DEVICES
To position the devices, take into account the operation characteristics of the system, the mechanical restrictions and the
IP protection degree of the devices.
For these reasons, two categories are identified:
Devices outside the driver’s cabin
Sensors
are usually positioned outside the driver’s cabin, except for
exceptional cases such as exposure to high temperatures.
Devices inside the driver’s cabin
CPU
and
Display
: due to their function and the IP protection degree, they
must be inside the driver’s cabin or, in any case, in a protected position.
The
HUB
can be positioned either outside or inside the driver’s cabin due to both its operation and its high degree of
protection.
The 433MHz whip aerial antenna, which is present on the HUB, must be fitted outside
The
Display
and the
Sensors
must be correctly oriented: for this reason, they are supplied with a mounting plate and a
mechanical joint onto which the support that is necessary for holding the device must be fitted.
The joint, which is made up of 2 U-shaped mechanical pieces, has been designed to be easily connected to the plate that
is present on the devices.
Find below the heights for the possible holes to be used for fixing it to the plate.