manualshive.com logo in svg
background image

SHORT POLE HEDGE TRIMMER ATTACHMENT — HTA2000S

10

 WARNING:

 Blades are sharp. When handling the blade 

assembly, wear non-slip, heavy-duty protective gloves. Do 
not place your hand or fingers between blades or in any 
position where they could get pinched or cut. NEVER touch 
blades or service the unit with battery pack installed.

TRANSMISSION GEARS LUBRICATION 

The transmission gears in the gear case need to be 
lubricated periodically with gear grease. Check the gear 
case grease level about every 50 hours of operation by 
removing the sealing screw on the gear case. There are 
three sealing screws with one on the side and two on 
the top.
If no grease can be seen on the flanks of the gear, follow 
the steps below to fill with gear grease up to 3/4 capacity.
Do not completely fill the transmission gears.
1.  Depending on which screw you are removing, hold 

the hedge trimmer on its side or lay it on its back 
so that the sealing screw to be removed is facing 
upwards (Fig. M & N).

2.  Use the wrench provided to loosen and remove the 

sealing screw.

3.  Use a grease syringe (not included) to inject some 

grease into the screw hole; do not exceed 3/4 
capacity.

4.  Tighten the sealing screw after injection.

STORING THE UNIT

 

Remove the battery pack from the tool.

 

Clean the tool thoroughly before storing it.

 

Put on the blade scabbard onto the cutting blade 
before storing or transporting. Use caution to avoid the 
sharp teeth of the blades.

 

If the hedge trimmer is removed from the power 
head and stored separately, fit the end cap on the 
attachment shaft to avoid dirt getting into the coupler.

 

Store the unit in a dry, well-ventilated area, locked-up 
or up high, out of the reach of children. Do not store 
the unit on or adjacent to fertilizers, gasoline, or other 
chemicals.

Protecting the environment

Do not dispose of electrical appliances as 
unsorted municipal waste, use separate 
collection facilities.
Contact your local government for infor-
mation regarding the collection systems 
available.
If electrical appliances are disposed of in 
landfills or dumps, hazardous substances 
can leak into the groundwater and get 
into the food chain, damaging your health 
and well-being.

Содержание HTA2000S













Отзывы: