Egholm Park Ranger 2150, Руководство оператора

Страница: 57 / 68

57
11
Operator’s Manual Park Ranger 2150 Operator’s Manual Park Ranger 2150
3.15 Tire change
When a tire needs changing the Park Ranger
2150 must only be lifted with a jack in the points
indicated at picture 1.
Before removing a wheel, the engine must be
stopped and the parking brake activated.
Warning
A tire change must be performed on a
flat and stable ground only!
To perform a tyre change you need following:
a jack with a minimum lifting force of 500kg, a
spare tyre and a wheel wrench.
1. Place the jack either in the front or at the rear,
depending on which tyre you need to change.
2. When the jack is placed, loosen the tyre bolts.
3. Then lift up the utility machine with the jack
until it is possible to remove the old tyre.
4. Change the tyre and tighten the bolts with your
hands.
5. Lover the jack and tighten the bolts once again
with the wheel wrench.
6. Retighten the bolts again after 5-10 hours.
Attention:
Only use tyre dimensions and tyre
pressure as specified in section 1.4
page 11.
Attention:
Changing tyres on rims may only be
carried out at an authorized workshop.
Front and rear Jack lifting points
Service and Maintenance