EGAmaster 56095, Руководство по эксплуатации

Страница: 22 / 38

22
POWER ON AND AUTO ZERO RESET
- Set the wrench horizontally on a level surface and let it sit without touching it, then gently
press to power on the digital QC wrench.
- After power on, auto zero-reset will be processed.
- ATTENTION:
1. If appeares during power-on process, it means this wrench has been torqued to
more than 110% of maximum torque.
2.
IMPORTANT!
When using the wrench ,the wrench must be placed flat (horizontally) on table or workbench
before any attempt is made to power up the unit.
If the user attempts these functions without following the instructions above ,the unit’s display will
begin to flash a series of four zeros in the top half of the screen.
In order to re-start the unit, long press .
ZERO RESET
- If necessary, Zero-reset will guarantee an accurate measurement.
- After power on, long press
button is for zero reset.
- Usually long press to zero reset the digital torque wrench before using the wrench.
- In M1 mode, keep the wrench steady without any disturbance and long press to do zero-
reset.
- In M2 mode, if an external force is applied to the torque wrench during zero-reset period, an
initial torque offset error will occur.
AUTO POWER OFF
- The wrench will auto power off after about 15 minutes idle for power saving. Press to
power on the wrench again.
CAUTIONS:
During communication period (send appears), the auto power-off function is disabled.
RESET THE WRENCH
- If the wrench does not function normally or appears, please go through the reset
process to reset the wrench.
- To reset the wrench, loosen the battery cap then tighten it to re-start. After reset, remember
to press .