EG Homevent VIGO 550A, Инструкция по установке и обслуживанию

Страница: 1 / 28

1.
Installation &
Maintenance Manual
VIGO 550A
Mechanical Ventilation with
Heat & Coolth Recovery
Read this manual carefully before using the product and keep it in a
safe place for reference.
This product was constructed up to standard and in compliance with regulations
relating to electrical equipment and must be installed by technically qualified
personnel. The manufacturer assumes no responsibility for damage to persons or
property resulting from failure to observe the regulations contained in this booklet.
Transport and storage
•
Do not leave the device exposed to atmospheric agents (rain, sun, snow, etc.).
•
Duct connections/duct ends must be covered during storage and installation.
Installation
•
After removing the product from its packaging, verify its conditions. Do not leave packaging within the reach of children or people with
disabilities.
•
Beware of sharp edges. Use protective gloves.
•
The device should not be used as an activator for water heaters, stoves, etc., nor should it discharge into hot air/fume vent ducts deriving
from any type of combustion unit or tumble dryer. It must expel air outside via its own special duct.
•
If the environment in which the product is installed also houses a fuel-operating device (water heater, methane stove etc., that is not a
“sealed chamber” type), it is essential to ensure adequate air intake, to ensure good combustion and proper equipment operation.
•
The electrical system to which the device is connected must comply with local regulations.
•
Before connecting the product to the power supply or the power outlet, ensure that:
- the data plate (voltage and frequency) correspond to those of the electrical mains
- the electrical power supply/socket is adequate for maximum device power.
•
For installation an omnipolar switch should be incorporated in the fixed wiring, in accordance with the wiring rules, to provide a full
disconnection under overvoltage category III conditions (contact opening distance equal to or greater than 3mm).
WARNING: Make sure that the mains supply to the unit is disconnected before performing any installation, service,
maintenance or electrical work!
WARNING: The installation and service of the unit and complete ventilation system must be performed by an
authorized installer and in accordance with local rules and regulations.
WARNING: If any abnormality in operation is detected, disconnect the device from the mains supply and contact a
qualified technician immediately.