Cummins 6.7L CM2350B CSP5
User
Guide
- 17 -
www.efilive.com
FlashScan Menu Navigation
FlashScan/AutoCal V3
FlashScan/AutoCal V3 supports two menu structures; the EFILive standard menu
and the user defined menu. Where a used defined menu is not installed, the
EFILive standard menu will be displayed.
Data Logging
1. Configure FlashScan/AutoCal V3 for BBX features if not already setup.
2. Connect your FlashScan/AutoCal V3 device to your vehicle.
3. Turn the vehicle ignition to the
On
position
4. Navigate to the Scan Tool -> F1 Select PIDs menu option.
5. Select correct controller type from BBX configured controllers.
6. Navigate to the F1 Scan Tool -> F2 Data Logging menu option.
7. Select F1: Record Data to commence the logging session.
8. The LCD will display recording status, elapsed time, frame count and the
selected PIDs.
9. A range of options are available while the Log is recording:
1. Select
✔
to pause/resume the log.
2. Select the up and down arrows to navigate through selected PIDs.
3. Select X, to save the log.
10. Start the vehicle and drive to record actual performance.
11. Stop the vehicle and turn the ignition off prior to selecting X on
FlashScan/AutoCal V3 to save the log file.
License and Flash a Controller
1. Configure FlashScan/AutoCal V3 for BBX features if not already setup.
2. Copy selected tune file(s) from your PC to
FlashScan/AutoCal V3
if not
already copied via Quick Setup during step 1.
3. Connect your FlashScan/AutoCal V3 device to your vehicle.
4. Turn the vehicle ignition to the
On
position (not the
Accessory
position.
Vehicle must not be cranked/running when flashing).
5. Navigate to the Tune Tool
menu and select F1: Tuning ->
F3 Program Full
menu option.
6. Navigate to the folder your tune file is located in and select
✔
to commence
the flash.
7. If the controller has not been licensed by the device previously, you will be
presented with an
Unlicensed Controller
message. Select
✔
to proceed with
licensing the controller, or
X
to exit.
8. Select
✔
to confirm licensing the controller and commence the flash, or
X
to exit.
9. When the flash process is complete, select
X
to close the flash completed
message.
10. The Reset Controller notification will be shown, and the controller reset process
will begin.
1. Turn the vehicle ignition Off.
