I
NSTALLING
H
ARDWARE
14
I
NSTALLING
H
ARDWARE
Installation problems are easier to avoid and diagnose if you proceed from the component to
the system level and verify functionality at each stage. The following procedure should take
place:
• Preparing for hardware installation or service procedures (see
)
• Installation sequence (see
)
• Checking the customer site (see
• Unpacking the E-42 (see
• Installing the E-42 and connecting it to the copier/printer and the network (see
• Completing the installation (see
)
–
Print a Test Page and a Configuration page.
–
If the E-42 requires a static IP address (for example, in a non-DHCP network
environment), work with the network administrator to configure it
as described on
–
Remind the site administrator to install the current user software on networked
computers that print to the E-42 (see
Printing
and
Utilities
, which are part of the user
documentation set.
Installation sequence
Because the E-42 is a node on the customer’s computer network, make sure that you
coordinate your scheduled installation with the network administrator at the customer site.
For Network Setup information, refer the network administrator to
Configuration and Setup
,
which is part of the user documentation set.
N
OTE
:
You can change the default language that is preinstalled at the factory using the
Configure tool available through Command WorkStation and WebTools. Start Configure,
choose Server > General > Choose Server Language, and then click Apply. It takes up to three
minutes to change languages.
1 Check installation requirements and verify site conditions.
If possible, obtain verification that the network is operational (see
).
2 Unpack the E-42 (see
).
3 Connect the monitor, keyboard, mouse, and furniture to the E-42 if applicable.
For more information on setting up the fainter, see
Furniture, 19-inch Monitor, Keyboard, and
Mouse for PRO Series.
4 Connect the interface cables (see
).
• Network cable (upper RJ-45)
