UPS MKD 1500 RT
Safety Instructions
MKD series
17
2.6
Operation
Before the loads are connected on the output, the basic configuration must be
set. The output voltage in relation to the loads is very important.
The UPS system includes energy storage (accumulators). As a result, the out-
put can carry power even if the UPS is not connected on the mains input side.
To completely switch off the UPS, disconnect the mains connector and then
press the "OFF" key for more than 3 seconds, wait until the UPS is switched off
and then disconnect the mains connection (remove the mains power cable
from the device). Make sure that no liquids or foreign bodies enter the UPS. To
protect the UPS, you should avoid a constant load at the output of over 80 %.
The display of the output load is only to be viewed as a reference value. To de-
termine the exact output load, separate measurements are required.
2.7
Handling Accumulators
Attention
– Danger of electric shocks and burns.
Accumulators can cause electric shocks and produce high short circuit
currents that can in turn lead to burns.
Unauthorised staff are to stay away from accumulators.
Do not bring accumulators into contact with heat sources or throw them
in the fire. There is an explosion danger!
Do not open or destroy accumulators. The released electrolyte is very
dangerous for people and the environment (searing danger for skin and
eyes, poisonous).