5
Effecta AB - Västra Rågdalsvägen 21 - 434 99 Kungsbacka - 0300 - 22320 - [email protected]
▀
In general
Effecta Smart is a lambda controlled boiler with a induced-draft fan. The boiler must be docked
to one or more accumulator tanks, loading should be done with a thermic valve that ensures
that the returning water temperature is high enough. Hot water is taken from the top of the
boiler and is led to the accumulator tank. The returning water from the tank is led to the bottom
of the boiler through a loading unit. The water is conducted from
the accumulator tank to the radiator circuit via a shunt valve that mixes the water to the desired
temperature.
Hot water preparation
For hot water storage, the accumulator tank must have a built-in hot water coil or equivalent.
The temperature of the hot water is adjusted by means of a mixing valve. The amount of hot
water that can be tapped depends on the accumulator tank temperature, size and the incoming
cold water flow.
Combustion
On the front of the boiler, there are two air inlets. The dampers are controlled by two motors
that receive a signal about the oxygen level from the lambda probe to obtain the best possible
environmental value and thus the best efficiency. Normally, the preset values do not need to be
adjusted for different wood types and humidity levels.
Disassmbly and disposal
It will be many years before your Effecta boiler is worn out, but it is important that you follow
the regulations in force at the time concerning disassembly and disposal of your boiler
The fuel
It is important to use the right kind of wood in your boiler. You find more information about
different kinds of wood on page 6.
Maintenance and service
This wood heater needs periodic inspection and repair for proper operation. It is against federal
regulations to operate this wood heater in a manner inconsistent with operating instructions in
this manual.
▀
Symbols in the document
Information
This symbol is shown with to indicate important information the installer should know and
understand. Neglecting this information can affect the performance of the product
Dangerous electricity
This symbol means that extra caution should be taken otherwise serious personal injury
might occur. When maintaining the product where this symbol is present the power must
be disconnected. All electrical wiring must be done by a Professional and comply with
current building regulations.
The product manual is a document that gets updated. You always find the latest ver-
sion on our webpage www.effecta.se
Hot surfaces
This symbol is shown when there is a risk of burns to people. Always wait for the boiler to
cool down before you do any service.