Effecta Komplett, Инструкция по установке и обслуживанию

Страница: 19 / 38

19 Effecta AB Västra Rågdalsvägen 21 434 99 Kungsbacka 46-300 - 22320 info@effecta.se
▀
Menu system
Information ►
Oper. pellets
Clean number
Igniter
Number starts
Displays the number of burner starts been done
Displays the number of hours ignitor has been lit.
Displays the number of hours the burners been running.
Displays the number of times the AERO unit has cleaned the burner.
Reset info
Resets the information above.
Service
►
Off
Interval
On
Clean at phase out
Option if cleaning should be done prior to or after the running cycle.
Time when AERO cleaning is allowed (ON).
Time when AERO cleaning is not allowed (OFF).
Choice of how often the AERO cleaning is to be done.
Number clean
The amount of blows in a cleaning cycle.
Clean pause
Cleaning at
Max time burner
Extern control
Time between each blow in a cleaning cycle.
Temperature when flue tubes is cleaned.
Max operation time of the burner before pause with AERO cleaning.
Choice of external START/STOP control to the boiler. The control could be
done either by NC or NO connection.
Installation
►
Fan pre oper.
Clean phase out
Phase out
Testblow start
Seconds the fan blows before ignition phase. Detection of ”old” flame.
Seconds the ignitor is active after the flame sensor has approved start value.
The fan speed before operation phase.
Time that the fan afterblows before standby or cleaning.
Ramp phase out
Time that the fan decreases it´s speed after running cycle.
Quick start
►
Temp down - min
Temp down - °C
Degrees temp shall fall before burner goes to quick start.
The time in which the temp. shall fall before burner activates quick start.
Flame sens
Quick start
►
►
Flame sensor
►
Time oper
Level oper
Level start
Time phase out
Set value where the burner goes from ignition mode to operation mode.
Lowest approved value in operation mode. If lower: ”ALARM BURNER”
Time before ”ALARM BURNER” when flame sensor lower than level oper.
Time the fan goes to max speed.
Menu options for the flame sensor.
Menu options for the quick start function.
Cleaning conv..
The amount of pulls of the solenoid valve for the flue tubes.