Efento SP. J.
Ul.Krupnicza 14/5
31-123 Kraków
currently in use. Devices automatically switch between technologies, depending on the inserted
SIM card
●
Registration status
- indicates current network communication status:
○ REGISTERED - registered to the network - this is typical status of the device;
○ NOT REGISTERED, SEARCHING - not registered to the network, searching for it - this
status may be seen during device power up, when it did not manage to attach to the
network yet;
○ NOR REGISTERED_NOT_SEARCHING - not registered to the network, not searching
for it - this status is seen mainly, if there is no network coverage;
○ REGISTRATION DENIED - network did not allow device to register
○ REGISTERED ROAMING - if the device is registered in roaming
○ REGISTERED EMERGENCY ONLY
○ UNKNOWN - all the other states
●
Registration reject cause
- if the device is not able to register to the network, the cause is
displayed in this field. Reject causes are described in 3GPP TS 24.301 Annex A
●
Signal strength
- strength of the signal
●
Communication status
- describing current status of communication with the server. Possible
statuses: OK, server error, encoding error, socket error, timeout, mismatch, unauthorized,
unexpected error, not registered, not supported
●
IMEI
- IMEI number of the cellular module
● ICCID
- ICCID of the SIM card in the device
●
IP address
- current IP address of the device
●
ECL
- ECL level. This parameter is a good indicator of the signal quality. The lower, the better.
ECL 1 or 2 may significantly reduce the battery life
●
Cell ID
- ID of the cell in to which the device is connected
●
Last communication timestamp
- timestamp of the last successful communication. All the
information on this card is refreshed during the communication / self check.
●
Last status check timestamp
- timestamp of the last self check. Self checks are performed on
the startup or may be performed on server’s demand. All the information on this card is refreshed
during the communication / self check.
Battery status
Efento sensors will inform you about the low battery level both on Efento Cloud platform and in Efento
Logger mobile application. Once a “low battery” status shows up, you will have 2-3 months to replace
the battery.
Efento sensors allow you to get the detailed information about the battery voltage and operation
parameters. In order to get the detailed battery parameters, connect to the sensor with Efento Logger ->
three dots in the upper right corner -> “Settings” -> “Device settings” -> “Battery status”.
You can get the following information:
●
Battery status
- information if the battery has to be replaced (“LOW”) or not (“OK”)
●
Battery Voltage
- current voltage of the battery in mV
| +48 574 753 980 | [email protected]
