M
M
F
F
W
W
-
-
Z
Z
D
D
-
-
B
B
A
A
-
-
U
U
K
K
-
-
0
0
0
0
6
6
P
P
a
a
g
g
e
e
1
1
1
1
o
o
f
f
2
2
4
4
A system from the MFW product family
4 Assembly and commissioning
1. Unpack all the transmission system's modules, and check them for transport damage. Report
any transport damage immediately to the responsible carrier. Please check that the delivery is
complete as per the delivery note.
2. Select mounting locations for the individual stations.
The delivery may contain master module, substation and expansion modules. The
system bus cable for connecting to the basic modules is supplied with the
expansion modules.
3. Configuring the modules “
” section.
4. Engage the basic module and any expansion modules that may be required on the mounting
rail.
5. Connect the 2 wire line and the input and output leads as per the
The length of the input and output leads should not exceed a maximum of 3 m.
6. If expansion modules are used then connect them to the
basic module with the system bus cable supplied via the
RJ45 sockets in the bottom of the modules. Loop the bus
connection for use with several expansion modules.
Please use the right RJ45 socket for master
modules with IEC interface (see illustration). The
left socket is prepared for use as an Ethernet
connection.
7. Connect the power supply to the basic module. The power supply of the expansion modules is
made via the system bus cable.
The length of the power supply leads should not exceed 10 m.
8. Switch on the power supply. The station is ready for operation once the green LED on the basic
module lights permanently. Please refer to the “
” section if this LED flashes.
