SYSTEM
Master auxiliary settings menu sets the AUX for ‘Pre’ or ‘Post’ fader.
If a Studio monitor check box is active the Studio monitor DIM function is
applied to this AUX upon opening a “Studio Microphone” fader.
‘GPI’ and GPO’
Here you can also set the type and shape of the GPIO’s: pulse (edge) or
continuously, inverted or not….
You can step trough the pages for the settings of the GPI and GPO 1 to 24 on
the D25 connectors on the back and for 25 onwards on an EA963 extender unit.
The same applies to the General Purpose Outputs.
NOTE THAT AN INVERTED GPI WILL BE ACTIVE WHEN NO CONNECTION IS MADE!! E.g. if you have
assigned a GPI to an input mute that channel will be muted if the switch is not connected!
If set to “EDGE” the GPI signal will toggle the function ’on’ on the first pulse and ‘off’ on the second.
Software power off, the D4 will stay in stand-by mode.
The unit has a hardware power switch in the back. It is recommended to use this
switch to shut off the unit. If the unit is mounted in a table were you cannot
reach this switch you can shut down (sleep mode) the unit in software.
By holding down the ‘settings’ rotary for 3 seconds the unit will power up again.
Please note: From this state the unit will also switch on if the (mains) power was
down and switched on again!
Eela Audio D4 manual
9
