Edwards XDS Series, Инструкция по эксплуатации

Страница: 20 / 36

A732-01-880 Issue D
Page 12 © Edwards Limited 2018. All rights reserved.
Installation
3.3 Unpack and inspect
Remove all packing materials, remove the pump from its packing box, remove the protective covers from the inlet
and outlet ports and inspect the pump.
If the pump is damaged, notify the supplier and carrier in writing within three days; state the Item Number of the
pump together with the order number and supplier's invoice number. Retain all packing materials for inspection. Do
not use the pump if it is damaged.
If the pump is not to be used immediately, replace the protective covers. Store the pump in suitable conditions, as
described in
Section 6.1 . Refer to Section 6.2 for disposal of materials.
3.4 Locate the pump
CAUTION
If the pump will be located inside an enclosure, ensure there is adequate ventilation at both ends of the pump,
so that the ambient temperature of the pump does not exceed 40 °C. A minimum space of 25 mm between the
pump and the enclosure walls is required.
Provide a firm, level platform for the pump. Locate the pump so that the Run/Standby switch is accessible.
3.4.1 Mechanical fixing
CAUTION
Use the four holes located on each corner of the pump base to secure the pump, if required. Edwards
recommends the use of M8 bolts.
3.5 Electrical installation
3.5.1 Check and configure the pump
CAUTION
Isolate the power supply before changing the voltage. Failure to configure the pump electrical supply correctly
can result in damage to the pump.
Ensure that the voltage shown on the voltage indicator (refer to Figure 1 , item 7) on the motor cover corresponds
with the electrical supply voltage. If not, change the configuration of the pump motor to match the supply voltage
using the following procedure.
WARNING
Use suitable lifting equipment to move the pump. Mechanical lifting equipment should be attached
to the lifting eyes; loose slings should not be used. Failure to do so can cause injury to people and
damage to the equipment. Refer to
Table 3 for the mass of the pump.
WARNING
Route and secure cables, hoses and pipework during installation to avoid possible risk of trips.