© Edwards Limited 2008. All rights reserved.
Page 35
Edwards and the Edwards logo are trademarks of Edwards Limited.
Transportation, storage and disposal
A590-00-880 Issue D
6
Transportation, storage and disposal
6.1
Transportation
Follow the procedure laid out in
Section 6.2
and then read form HS1 and fill out form HS2, which can be found at the
back of this manual.
6.2
Storage
CAUTION
Drain the cooling-water from the iH system, if you will transport or store it in conditions where the cooling-water
could freeze. If you do not, the cooling-water may freeze in the iH system and damage the pump(s) and/or the
cooling-water pipelines.
Store the iH system as follows:
1. Follow the procedure set out in
Section 5.2
.
2. Store the iH system in clean dry conditions until required.
3. When required for use, prepare and install the iH system as described in
Section 3
of this manual.
6.3
Disposal
Edwards products are supported by a world-wide network of Edwards Service Centres. Each Service Centre offers a
wide range of options including disposal. Refer to
Section 7.2
for more information.
Pump system materials suitable for recycling include cast iron, steel, SG iron, PTFE, stainless steel, brass, aluminium,
zinc alloy, nickel, mild steel, ABS.
Take particular care with the following:
z
Fluoroelastomers which may have decomposed as the result of being subjected to high temperatures.
z
Components which have been contaminated with dangerous process substances.
WARNING
Do not drain the oil from the pump(s) whether dangerous substances have been pumped or not.
You must fit blanking plates to seal all vacuum inlet and outlet ports (to prevent possible oil
leakage). You must ensure that the system is correctly labelled, if in doubt contact Edwards.
WARNING
Dispose of the system and any components safely and in accordance with all local and national
safety and environmental requirements.
Содержание iH1000
Страница 3: ......
Страница 4: ...This page has been intentionally left blank...
