Edwards D395-90-000, Инструкция по эксплуатации

Страница: 14 / 36

D395-90-880 Issue E
Page 8 © Edwards Limited 2010. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
INSTALLATION
3.2.2 Panel mounting
If the Controller is to be panel mounted, follow the directions given in Figure 5 and Figure 6 below.
CAUTION
Allow 150 mm at the rear for cables. Allow 50 mm top and bottom and 15 mm to the sides for sufficient air
circulation.
Figure 5 - Panel cut-out required
Figure 6 - Panel mounting the ADC
z
Make a cut-out in the panel according to Figure 5 . The minimum panel thickness should be 1.5 mm.
z
Fit the panel mount clamps to the case, by placing into the recesses and sliding towards the rear of the case.
Use both the left and right or the top and bottom mounting positions.
z
Slide the Controller into the panel from the front. The Controller is a push fit and will be retained by the
spring clamps.