Edwards A34310940, Инструкция по эксплуатации

Страница: 30 / 56

Figure 8 Motor voltage selection: single-phase motors, 110/200-240 V 50 Hz and
115-120/200-240 V 60 Hz
B A
CS
/111
8/
A
1
3
4
5
7 8
6
2
A. Top view of motor B. Internal view of top of motor
C. On/Off switch
A. Top view of motor B. Internal view of top of motor
C. On/Off switch
1. Terminal box cover 2. Electrical inlet socket
3. On/Off switch 4. Position 'I' (on)
5. Position 'O' (off) 6. Voltage selector switch
7. Position 'II' (high voltage setting
200
‑
240 V)
8. Position 'I' (low voltage setting
110
‑
120 V)
1. Terminal box cover 2. Electrical inlet socket
3. On/Off switch 4. Position 'I' (on)
5. Position 'O' (off) 6. Voltage selector switch
7. Position 'II' (high voltage setting
200
‑
240 V)
8. Position 'I' (low voltage setting
110
‑
120 V)
4.7 Electrical installation: three-phase motors
4.7.1 Connect the electrical supply to the motor
WARNING:
Ensure that the electrical installation of your pump
‑
motor conforms with your local
and national safety requirements. It must be connected to a suitably fused and
protected electrical supply and a suitable earth point.
CAUTION:
If your pump
‑
motor can be used with more than one voltage range, you must ensure
that the motor is configured for your electrical supply voltage. If you do not, you may
damage the motor.
Note:
The pump will restart automatically when the electrical supply is restored after an
interruption. If you do not want the pump to restart automatically, use electrical control
equipment which must be reset manually.
Page 26
A34310880_T - Installation