EDT VisionLink RCX, Руководство пользователя

Страница: 15 / 17

VisionLink RCX Power Supply
EDT, Inc. 2016 August 30 15
Unlike the DB9 in the male assembly, this DB9 does not supply power to the extender. Instead, a red wire (power) and
a black wire (ground), each 24 inches long, are left loose so you can hook up your own power source. The required
power is 4.75 to 28 V DC.
Table 8 shows the pinout and how the standard firmware uses each wire. DB9 pins 1, 4, and 6 are wired together and
unconnected, 7 and 8 also are wired together, and 9 also is unconnected; these signals are not otherwise used.
Power Supply
Each extender has an internal switching regulator that supports voltages of 4.75 to 28 V DC. For pin information and
polarity on the standard Switchcraft and optional Lemo power connector, see
Power Connector on page 13 .
Table 9 shows the base-mode power supply requirements.
Table 8. Pin assignments – female DB9 cable
Lemo pin Wire color DB9 pin Standard firmware Signal level
– – 1 [unused] –
– – 6 [unused] –
1 (output) green 2 AUX_TX, primary auxiliary transmit UART RS232 (at DB9) to CMOS +3.3 V (at Lemo)
2 red – power to extender +4.75 to +28 V (red wire out)
3 orange 7 reserved –
4 brown 8 reserved –
5 white 4 reserved –
6 (input) blue 3 AUX_RX, primary auxiliary receive UART RS232 (at DB9) to CMOS +3.3 V (at Lemo)
7 black – ground ground (black wire out)
Table 9. Power supply requirements
U.S. International
Voltage in 100–240 V, 50–60 Hz

from AC mains
100–240 V, 50–60 Hz

from AC mains
Voltage out 5 V, 1 A DC; power supply
includes a U.S.-standard

power plug
5 V, 2A DC; power supply
includes four international

power plug adapters
Connector,
standard Switchcraft 760K Switchcraft 760K
Connector,
Lemo option FGG.0B.307.CLAD.56 FGG.0B.307.CLAD.56