RCX C-Link Series
Power Supply
EDT, Inc.
2011 June 29
19
Table 11
shows the base-mode power supply requirements for an extender at the camera end.
In full mode with a standard framegrabber, the power required for each end (camera and framegrabber) is
always under 6 watts – and typically closer to 4 watts – per end. This power is spread across two extender
(typically 1.5 watts for the X channel unit, and 2.5 watts for the YZ channel unit). The two extenders at the
camera end can use either of the two power supplies with the Switchcraft connectors, while the two
extenders at the framegrabber end can receive power from the EDT resync cable through a female DB9
connector. The resync cable connects to the extenders through two interchangeable Lemo connectors.
Table 11. Base-mode power supply for extender at camera end
U.S.
International
International with DB9 connector
Voltage in
100–240 V, 50–60 Hz
from AC mains
100–240 V, 50–60 Hz
from AC mains
100–240 V, 50–60 Hz
from AC mains
Voltage out
5 V, 1 A (DC); power supply
includes a U.S.-standard
power plug.
5 V, 2 A (DC); power supply
includes four international
power plug adapters.
5 V, 2 A (DC); power supply
includes four international
power plug adapters.
Connector
Switchcraft 760K
Switchcraft 760K
DB9 female