A
A
B
Assembly Instructions
Figure 5
•
Attach two (2) beams (B) to the end frame
posts (A) starting at the bottom level to
establish the left and the right sides of the
units (see figure 1). Be sure the tapered end
of the post slots are facing down and the
long slotted holes on the ledge of the beam
are facing the bottom when assembling.
After the beams have been placed in both
end frame post slots (front and back), tap
the beam down at both ends with a rubber
mallet to help drive the inside beam brack-
et tabs into the slots to secure the connec-
tion. Continue assembling each level from
bottom to top level (front and back). If the
beam bracket tabs become bent due to
mishandling, it may be necessary to adjust
the tabs back to their proper form.
•
Even though the levels can be adjusted to
any height, it is recommended the four (4)
levels be evenly spaced for maximum
stability (see figure 2).
•
After all levels have been assembled, place
a canoe clip (E) into the hole of each of the
beam end bracket, then tap the plastic clip
with a mallet to drive it into the square
hole of the end frame post to secure the
beam to the end frame (see figure 3).
•
Insert three (3) tie channels (C) on each lev-
el by aligning the bottom holes located on
both ends of the tie channel to the long
slotted holes on the inside bottom ledge of
the beams. Use the bolts (F) and nuts (G)
provided to properly fasten the tie channel
to the beam on both ends (see figure 4).
•
Finally insert a wire deck (D) on each level
(figure 5). Assembly is now complete.
Figure 1
Should you have any comments, damage, missing parts, or problems with assembly of this unit contact us:
Chat: www.edsal.com/chat or www.edsal.com/contact
Email: [email protected]
Phone: 773
-
475
-
3131
To obtain replacement parts please provide:
Model Number, Part Number & Description, Location Purchased, and Date Purchased
Edsal Manufacturing Co. LLC
1555 W. 44th Street
Chicago, IL 60609
US Patents & Patents Pending
Rev: C082720_V6tc_V5b
E
Figure 3
D
Figure 4
C
Inside Bottom
Edge of Beam
Figure 2
A
B
Tapered
end of post
slot faces
down
Inside view
of beam
Inside
bracket
tabs
Bottom ledge has
long slotted holes
Tap down
lightly
