Rollers do not operate
1. Power cord may not be plugged
1. Check the power cord
after press RUN
in.
2. Check the switch is on
button.
2. Power switch is at OFF mode.
3. Check the emergency switch
3. Emergency switch may be at
is off
ON mode.
4. Release STND-BY switch by
4. It may stay at STAND-BY mode.
press the STND-BY button
Heat shoe is not
1. It is set at the cold mode
1. Change the function to hot
heater up.
2. Memorized temp may be lower
lamination.
than atmosphere temp.
2. Set proper temperature for the
work
*Noise from friction
1. Film tension is too tight.
1. Adjust the film tension.
between the shoe
2. Temperature of heat shoe is too
2. Reduce the friction noise by
and film is loud, while
high
adjusting temperature on the
machine's operating
heat shoes.
at a slow speed.
*Wrinkled lamination
1. Film tension is not proper, too
1. Adjust film tension.
result
tight.
2. Put the Idle Bar at right position.
2. Idle Bar in line with lower roller
is not in proper position.
*Result of lamination is
1. Temperature on the heat shoe
1. Increase the temperature on the
not clear
is too low or lamination is too
heat shoe or decrease the
speedy.
speed.
4. Bolt(M8X12) : 6EA
2. Fuse(50T) : 1EA
5. Washer-spring(
Φ
8) : 6EA
(AC 250V 6.3A)
3. Fuse(65TS) : 1EA
6. Bolt-core : 2EA
(AC250V 15A)
SPARE PARTS
It's not out of order
Cause
Check point
Symptom
1. Core(76mm) :6EA
- 25 -
EDNord - Istedgade 37A - 9000 AAlborg - telefon 96333500
