2. Prevent children from accessing the machine.
Extreme Heat Will Cause Injury
4.Make certain that the machine is connecterd to an adequate power source.
1.Do NOT Allow the machine to run with only one roll of film installed.
The melted resin will adhere to one roller and ruin future laminations.
2.The width of film should be bigger than the material, and width of upper side,
and lower side of film should be same in order not to allow melted resin to adhere
to the rollers.
3.Be sure to adjust the film tension while in operation.
If the tension is too tight, it could cause the film to stretch.
4.After work, you should clean the resin from the rollers before beginning the next
operation.
5.Please check the lubricant after long operation or you do not use for a long time.
6.Check the chain linking each gear is not loosened.
The limit tension allowed is 3mm.
IMPORTANT SAFETY CONCERNS
MAINTENANCE
1.Please be cautious that neck tie, necklace, long hair, clothes are kept well away
while operation.
5.Do not use any other purposes other than the lamination.
3.Place the machines on the plated place in order to prevent the machine from damage.
- 24 -
EDNord - Istedgade 37A - 9000 AAlborg - telefon 96333500
