6. It is ready when the LCD window shows
9.Push
11. Push
4. Set pressure lever to "Laminating" position.
5. Increase temperature of the hot shoe. If the temperature is memorized for the
button to choose the correct location.
7. To set the film tension properly, please use the Tension Adjustment Knob while
3. Turn on the power switch on the backside of the product. (Emergency Switch must
be turned to the "OFF" position.
LAMINATING STEPS
1. HOT LAMINATING
1. Properly plug in the machine.
2. Set up your film.
the better operation.)
side for perfect laminations.
13. The document, which has been just laminated, is pretty hot and easily bent.
8. Set documents on the table. (You should allow at least 5mm(1/4") room on each
on the control panel. If the rollers don't run, please check
the emergency switch whether it is located at "ON" position or not.
laminator, please push button, then use or
and the buzzer rings sound
three times. (It takes about 10minutes depending on setting temperature.)
14. After finishing your work(laminating), change the position of the Pressure Lever
10. Push document into the rollers and start laminating.
when the laminating is finished. Cut the document with the cross
cutter, if needed.
you are checking laminating condition (The lower film tension would make
12. It would be convenient, if the table guide is set at the proper position when
from the left/right side of the object with the Slitters.
Try not to touch the document until it has cooled down.
the machine is continuously laminating. It is possible to cut unnecessary excess
15. Turn the Power switch off.
to "Hard Board, 1mm(40mil)".
RUN
STOP
MEMORY
- 18 -
EDNord - Istedgade 37A - 9000 AAlborg - telefon 96333500
