37
Appendices
Use this mode when using the standard MIDI driver provided with the operating system.
* Standard driver mode supports only Windows XP SP2 or later, and Mac OS X.
If you are using Windows 98/Me/2000/XP or XP SP1, or if you are using Mac OS 9, you must
turn the ADVANCED (mode select) Switch ON before you connect the UM-1EX to your
computer.
1.
With the UM-1EX left unconnected, start up your computer.
* Disconnect all USB cables other than those for your keyboard and mouse, and restart your Macintosh.
2.
Exit all currently running software (applications).
3.
Set the UM-1EX’s
ADVANCE DRIVER switch (mode switch)
to
OFF
.
4.
Connect the UM-1EX to the computer.
The driver is automatically installed.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after connecting the UM-
1EX is required before the unit will operate normally.
These settings enable use of the UM-1EX with sequencer software that uses Windows or
Macintosh standard device settings.
If using sequencer software that does not utilize Windows standard device settings, make the
device settings within the sequencer software. For instructions on the device settings for your
particular sequencer software, refer to the owner’s manual that was supplied with it.
When using Windows XP
1.
In accordance with Steps 1 in
“Windows XP users”
(p. 18), open the
Audio
tab in the
Sounds and
Audio Devices Properties
dialog box.
2.
Click the
▼
for
[Default device]
in the
MIDI music playback
menu and select the
USB audio
device
from the list that appears.
Depending on your computing environment, “(2)” or some other number may be added at the end
of the port name.
When using Macintosh (Mac OS X)
The procedure is the same as for Advanced mode. Refer to
“Setting the driver”
(p. 23).
About Standard Driver Mode
Installation of the standard driver
Standard driver settings
UM-1EX_multi1.book 37 ページ ２００５年１１月１日 火曜日 午後３時１９分
