Host Address This is the IP address of the host in the Internet that will
have management/configuration access to the Broadband
router from a remote site. This means if you are at home
and your home IP address has been designated the
Remote Management host IP address for this router
(located in your company office), then you are able to
configure this router from your home. If the Host Address is
left
0.0.0.0
this means anyone can access the router’s web-
based configuration from a remote location, providing they
know the password.
Click the
Enabled
box to enable the Remote Management
function.
Note
: When you want to access the web-based
management from a remote site, you must enter the
router’s WAN IP address (e.g. 10.0.0.1) into your web-
browser followed by port number 8080, e.g. 10.0.0.1:8080
(see below). You’ll also need to know the password set in
the Password Setting screen in order to access the router’s
web-based management.
Port
The port number of remote management web interface.
Enabled
Select “Enabled” to enable the remote management
function.
Click <
Apply>
at the bottom of the screen to save the above
configurations. You can now configure other advance sections or start
using the router (with the advance settings in place)
2.2 WAN
Use the WAN Settings screen if you have already configured the Quick
Setup Wizard section and you would like to change your Internet
connection type. The WAN Settings screen allows to specify the type of
WAN port connect you want to establish with your ISP. The WAN settings
offer the following selections for the router’s WAN port,
Wireless-WISP,
Dynamic IP
,
Static IP
Address
,
PPPoE
,
PPTP
,
L2TP
,
Telstra Big Pond
,
DNS
and
DDNS
.
31
