11
MOUNTING THE COMPONENTS OPTIONAL
- Install the feeder tube connection (
B
supplied) on the tank body (on the side where the boiler will be located);
securing it with 4 M6 screws (Pic. 1).
- On the opposite side (in the symmetrical position) install the closing plate (
C
supplied) securing it will 4 M6
screws (Pic. 2).
- Position the feeder tube support (
D
supplied) and fasten it to the tank body using 2 M6 screws and nuts (Pic. 3).
- Insert the feeder tube (
E
) with the feed screw
making sure the feed slot is positioned facing upwards (Pic. 4).
- Insert the feeder tube (
F
) facing the rear side of the boiler (Pic. 5) and fasten it to the support (
D
) using the
screws provided (Pic. 6).
- Remove the pre-cut lidon the back of the boiler (Pic. 7), unscrew the fastening screws of the closing flange lo-
cated under the pre-cut lid and replace it with a flexible pipe connection flange (
H
-Pic. 8).
- Connect the flexible tube (
N
-photos 10 and 11) to the conveyor tube (
F
- photos 5-10) and to the flexible tube
connection flange (
H
-photos 8 and 9), and secure it using the supplied cable ties.
Note: the flexible pipe (G) must be positioned so that it carries the pellets to the tank without causing bot-
tlenecks (Pic. 10); verify the unit’s proper functionality during the initial loading operations, and use sili-
cone to seal any powder leaks that may be encountered.
Pic.
1
Pic.
2
Pic. 3
Pic. 4
Pic. 5
Pic. 6
Pic. 7
Pic. 8
Pic. 9
B
C
D
F
G
Pic. 10
G
ENGLISH
D
D
E
H
H
F
G