EdilKamin fLAMMA, Инструкция по установке, эксплуатации и обслуживанию, Страница: 11 / 24

11
ENGLISH
INSTALLATION
REMARKS ON INSTALLATION
Note that:
• the appliance may only be installed by a qualified
technician authorised to issue the declaration of
conformity.
• the appliance must be installed and operated
in compliance with local and national law and
european regulations. the applicable Italian
regulation is UNI 10683.
• If installed in a condominium, the appliance must
be approved by the administrator.
We give some general instructions below, however
these do not obviate the need to comply with local
regulations and do not affect the installer’s liability for
the installation.
Checking the suitability of the installation
space
• the room must have a volume of at least 20 m
3
• the floor must be able to bear the weight of the
product and its accessories.
• level the appliance
• the appliance may not be installed in a bedroom,
bathroom or in the same room as other equipment
which draws air for combustion from the room
itself, or in any area with an explosive atmosphere.
Any extraction fans operating in the same room or
area as the product, may affect its draw.
• In Italy, check the compatibility pursuant to UNI
10683 and UNI 7129 in the presence of gas fired
products.
protection from heat and safety clearances
the surfaces of the building adjacent to the product
must be protected against overheating.
the insulation to be used will depend on the type of
surface in question.
the product must be installed in observance of the
following safety instructions:
- minimum clearance at the sides and back of 20 cm
from flammable materials.
- no flammable materials may be kept closer to the
front of the appliance than 80 cm.
If installed on a flammable or combustible floor, or
which is not capable of bearing its load, use steel or
glass plates under the stove to distribute the load.
Contact the retailer for such optional equipment.
EXTERNAL AIR INTAKE
to re-integrate burnt oxygen during stove functioning,
you need to have an installation premises suitable for
the external air intake.
In general, we suggest two ways for ensuring a proper
flow of combustion air.
Indirect air intake
Install an intake at floor level with effective area (net of
the mesh or other protective equipment) of at least 200
cm
2
(16 cm dia.).
to prevent draughts, we recommend installing the
intake behind the stove or behind a radiator.
Installing it in front of the appliance will create
unpleasant draughts.
Direct air intake
Install an air intake of effective area (net of the mesh or
other protective equipment) at least equal to that of the
air intake at the back of the product.
Connect the air intake to the appliance’s air intake with
a tube (which may also be flexible).
We recommend not exceeding a 3 m length depending
on the draw of the flue.
the air maty be drawn from an adjacent room only if:
• the flow is taken from permanent and unobstructed
openings communicating with the outdoors;
• the adjacent room is never in underpressure
relative to the outdoors;
• the adjacent room is not a garage. subject to fire
hazard, a bathroom or bedroom
• the adjacent room is not a shared room in the
condominium.