Edgetech PORT LF, Руководство пользователя по оборудованию

Страница: 29 / 79

4-1

SECTION 4: OPERATING INSTRUCTIONS
This section of the manual covers instructions for normal operations, including opening and closing the
Transducer End.
To start using the PORT, the Housing must be opened so that the battery can be plugged in. The
instructions for this continue below in sub-section 4.1.
4.1 Turning the Unit On
Push Off Release Transponders (PORT) are carefully tested and shipped from the factory with a new
battery pack installed. Unless otherwise requested, all battery packs are disconnected in transit, to
prolonging the battery life.
To use the PORT LF, the Housing MUST be opened so that the battery can be plugged into the JP3 header
connector on the electronic board. Then, the unit must be closed and the Housing purged.
4.1.1 Removing the Purge Port Plug
The Purge Port Plug keeps the unit sealed
.
If it is not removed first, the unit will not open.
1. Remove the anti-rotation block from the Release End of the instrument (Black Delrin block that
keeps the Release Link from turning) by unscrewing the two nylon screws that hold it in place as
shown in
F
IGURE
4-1 .
Figure 4-1: Unscrew the Anti-Rotation Block to Remove it