Edgetech Model 3100P Sub-bottom Sonar System, Руководство по оборудованию

Страница: 35 / 66

3-1
SECTION 3: SETUP AND ACTIVATION
Setup and test of the EdgeTech 3100-P Sub-Bottom Profiling System involves:
1. Unpacking, inspecting, and connecting the system components.
2.
Connecting a navigation system and external sonar systems if required
3. Activating the system
4. Verifying operation using the EdgeTech DISCOVER SB software.
This section provides instructions on how to perform these tasks, as well as information on how to deploy
and tow the tow vehicle.
3.1 Unpacking and Inspection
The 3100-P Portable Topside; SB-424 or SB-216S Tow Vehicle; and 35-Meter Kevlar-Reinforced Tow Cable
are shipped in separate, reusable, heavy-duty transport cases. Essential cables and documentation are
also included.
Before unpacking the system components, inspect the shipping containers for any damage. Report any
damage to the carrier and to EdgeTech. If the shipping containers appear free of damage, carefully unpack
the components, and inspect them for damage. Also check the packing list and verify that all the items on
the list are included.
Again, if any damage is found, report it to the carrier and to EdgeTech. If any items are missing,
immediately contact EdgeTech. Do not install or operate any equipment that appears to be damaged.
Although the items shipped may vary, depending on the customer requirements, the 3100-P Sub-Bottom
Profiling System typically includes the following:
•
3100-P Portable Topside
•
Laptop Computer
•
SB-424 or SB-216S Tow Vehicle
•
35-Meter Kevlar Reinforced Tow Cable
•
AC power cords (1)
•
DC power / Ethernet cable
•
Recovery thumb drive
•
Software CDs and Electronic Manuals
• Consumables kit
After unpacking the system components, be sure to safely store the shipping containers, including any
packing materials, for later use. When transporting or storing the system, all items should be packed in