11
ENGLISH
INSTRUCTION MANUAL
Introduction
To get the most out of your new massage table,
please read through these instructions before use.
Please also save the instructions in case you need
to refer to them at a later date.
Special safety instructions
Check before use that the massage table is on a
flat, stable surface and that it is standing on all
four legs.
Do not exceed the maximum weight load of the
massage table. The weight load is the sum of the
weight of the user plus the pressure applied to the
user by the masseur.
The massage table must not be exposed to water
or moisture, and it must not be stored in locations
with high humidity.
Technical specifications
Size: 195×70×64-90 cm
Maximum weight load: 220 kg
Main components
1. Face/head support
2. Arm support
3. End
4. Leg
5. Height adjuster
6. Cross brace
7. Cord drive
8. Arm rest
9. Table surface
10. Carrying handle
Use
Place the folded massage table on its side with the
carrying handle (10) facing upwards.
Open the massage table and pull the head support
and armrests out.
Stand behind the massage table and push it out.
Avoid allowing the vinyl sides of the massage table
to slide along the floor. The cord drive (7)
automatically folds the legs out when the massage
table is pushed out.
Take hold of the middle of the massage table and
lift it up. Position the massage table so that it is
standing on all four legs. Check that the table is
fully erected and that the table surface (9) is
horizontal.
Adjust the height of the table using the height
adjusters (5) on each leg. All the legs must be
adjusted to the same height.
Push the head support (1) into the end of the
massage table and adjust it to the required height
and angle.
Suspend the arm support (2) from the head
support bars and adjust the height using the
straps.
Push the arm rests (8) into the holes on the side of
the massage table.
Allow the user to lie on the massage table and
adjust the head and arm supports as required.
1
2
3
4
5
6
7
8
9
1 0
