Edge EDA2000.4AB-E6, Руководство пользователя

Страница: 9 / 16

12. CH3 / 4 Gain control
This control is used to match the input signal of the source to the amplifier. See the setup section for
more details.
13. CH3 / 4 Subsonic filter
This control is used to set the subsonic filter which is used to limit the very low frequency
information passed to the subwoofer. The frequency is adjustable between 10hz and 100Hz.
14. CH3 / 4 Low Pass Filter (LPF)
This control is used to set the crossover frequency for the amplifier when LPF is
selected. The frequency is adjustable between 50Hz and 500Hz (500Hz and 5kHz when 10x
frequency multiplier is engaged)
15. Low Pass Filter (LPF) Frequency multiplier switch
This Switch is used to select 1x and 10x frequency multiplier for the Low Pass Filter.
16. CH3 / 4 Crossover mode select switch
This Switch is used to set the crossover mode to HPF, FULL or LPF operation.
17. CH3 / 4 High Pass Filter (HPF)
This control is used to set the crossover frequency for the amplifier when HPF is
selected. The frequency is adjustable between 50Hz and 1kHz (500Hz and 10kHz when 10x
frequency multiplier is engaged)
18. CH3 / 4 Bass boost frequency
This control is used to set the bass boost frequency which is adjustable between 35Hz and 120Hz
19. CH1 / 3 Bass boost Control
This control is used to add bass boost which is adjustable between 0dB and +12dB.
20. Power / protect LED
If the amplifier is operating normally, the GREEN LED will illuminate.
If the amplifier is in protection mode the RED LED will illuminate.
21. Power terminals
Used to connect DC power to the amplifier. See the power connections section for more details.
22. Speaker terminals
Used to connect speaker cables to the amplifier. See the wiring configuration section for more details.
Terminals And Connections (Cont)
9
EDA2000.4AB-E6