Edge EDA2000.4AB-E6, Руководство пользователя

Страница: 6 / 16

1. Power / protect LED
If the amplifier is operating normally, the GREEN LED will illuminate.
If the amplifier is in protection mode the RED LED will illuminate.
2. Low level input
For connection to any source (head unit) with a low level output. This is your RCA output from the
source (headunit)
3. Gain control
This control is used to match the input signal of the source to the amplifier. See the setup section for
more details.
4. Subsonic filter
This control is used to set the subsonic filter which is used to limit the very low frequency
information passed to the subwoofer. The frequency is adjustable between 10hz and 500Hz.
5. High Pass Filter (HPF)
This control is used to set the crossover frequency for the amplifier when HPF is
selected. The frequency is adjustable between 50Hz and 500Hz (500Hz and 5kHz when 10x
frequency multiplier is engaged)
6. High Pass Filter (HPF) Frequency multiplier switch
This Switch is used to select 1x and 10x frequency multiplier for the High Pass Filter.
7. High Pass Filter (HPF) select switch
This Switch is used to turn the High Pass Filter (HPF) on or off.
8. Bass boost Control
This control is used to add bass boost centred at 45Hz to the amplifier with 0dB, 6dB and +12dB
selectable.
9. Low Pass Filter (LPF)
This control is used to set the crossover frequency for the amplifier when LPF is
selected. The frequency is adjustable between 50Hz and 500Hz (500Hz and 5kHz when 10x
frequency multiplier is engaged)
10. Low Pass Filter (LPF) Frequency multiplier switch
This Switch is used to select 1x and 10x frequency multiplier for the Low Pass Filter.
11. Low Pass Filter (LPF) select switch
This Switch is used to turn the Low Pass Filter (LPF) on or off.
12. Low level output
RCA output used to connect an additional amplifier or audio device.
13. Remote input socket
Used to connect the remote level control to the amplifier.
14. Power terminals
Used to connect DC power to the amplifier. See the power connections section for more details.
15. Speaker terminals
Used to connect speaker cables to the amplifier. See the wiring configuration section for more details.
Note:
For bandpass operation both HPF and LPF switches must be engaged.
1 3 2 4 9 8 6 7 5 10 11 12 13 14 15
6
Terminals And Connections
EDA4500.2AB-E6