Edge DBX Series, Руководство пользователя

Страница: 6 / 20

1. High level input
For connection to the speaker output of your source (head unit). This is to be used if the source
(headunit) does not have a low level output.
2. Low level output
RCA output used to connect an additional amplifier or audio device.
3. Low level input
For connection to any source (head unit) with a low level output. This is your RCA output from the
source (headunit)
4. Gain control
This control is used to match the input signal of the source to the amplifier. See the setup section
for more details.
5. Phase adjust
This control is used to set the speaker output phase for the amplifier and is adjustable between
0° and 180°
6. Bass boost Control
This control is used to add bass boost to the amplifier centered at 45Hz and is adjustable between
0dB and +12dB.
7. Remote input socket
Used to connect the remote level control to the amplifier.
8. Subsonic filter
This control is used to set the subsonic filter which is used to limit the very low frequency
information passed to the subwoofer. The frequency is adjustable between 10hz and 50Hz.
9. Low Pass Filter (LPF)
This control is used to set the crossover frequency for the amplifier when LPF is
selected. The frequency is adjustable between 30Hz and 150Hz.
10. Mode select switch
Used to select MASTER or SLAVE operation for the amplifier.
• Master output
Used to connect to the SLAVE INPUT socket of the second EDA amplifier when used as a
strapped pair. See strapped amplifier configuration for more details.
• Slave input
Used to connect to the MASTER OUTPUT socket of the first EDA amplifier when used as a
strapped pair. See strapped amplifier configuration for more details.
11 Slave / master output
Used to connect speaker cables to the amplifier. See the wiring configuration section for more
details
12. Speaker terminals
Used to connect speaker cables to the amplifier. See the wiring configuration section for more details
13. Power / protect LED
If the amplifier is operating normally, the GREEN LED will illuminate.
If the amplifier is in protection mode the RED LED will illuminate.
14. Power terminals
Used to connect DC power to the amplifier. See the power connections section for more details
NOTE:
When using high level input, the REM terminal will now output a +12v feed that can be used to turn
other devices in the system that do not have auto turn on.
1 2 3 4
5
6 8 10 12 13 14
7 9 11
1 2 3 4
5
6 8 10 12 13 14
7 9 11
6
Terminals And Connections