Quick Start Guide
– 2 –
Mount the Router in an EIA-310 Rack
1.
For 300mm-deep rack: Using the four front screw holes, attach
each of the brackets to the router with four of the included bracket
screws.
2.
For 280mm-deep rack: Using the four recessed screw holes, attach
each of the brackets to the router with four of the included bracket
screws.
3.
Use the screws and cage/clip nuts supplied with the rack to
secure the router in the rack.
Ground the Router
Verify Rack Ground
Ensure the rack is properly grounded and in compliance with
international and local standards. Verify that there is a good electrical
connection to the grounding point on the rack (no paint or isolating
surface treatment).
Attach Grounding Wire
Attach the grounding wire (#6 AWG/16 mm
2
) to the grounding point on
the router’s rear panel or side panel. Then connect the other end of the
wire to rack ground.
Connect Power
a. AC Power
Install one or two AC PSUs in the router, if they are not already installed
in the factory. Then connect an external AC power source to the PSUs.
b. DC Power
Install one or two DC PSUs (part number CRXT-T0T12B only) in the
router, if they are not already installed in the factory.
Connect an external DC power source to the PSUs. Or, connect to a no-
tolerance DC mains supply with a UL/CSA-approved circuit breaker
rated at 16 A.
Warning:
For a safe and reliable installation, use only
the accessories and screws provided with the device. Use
of other accessories and screws could result in damage to
the unit. Any damages incurred by using unapproved
accessories are not covered by the warranty.
Avertissement:
Pour une installation sûre et fiable,
utilisez uniquement les accessoires et les vis fournies avec
l’appareil. L’utilisation d’autres accessoires et vis pourrait
endommager l’appareil. Les dommages causés par
l’utilisation d’accessoires non approuvés ne sont pas
couverts par la garantie.
Caution:
The device must be installed in a restricted-access
location.
Attention:
le périphérique doit être installé dans un
emplacement à accès restreint.
Note:
The router has the Open Network Install Environment
(ONIE) software installer preloaded, but no router software
image. Information about compatible router software can be
found at
www.edge-core.com
.
Note:
The drawings in this document are for illustration only
and may not match your particular model.
1
1
2
3
Caution:
The earth connection must not be removed unless
all supply connections have been disconnected.
Attention:
Le raccordement à la terre ne doit pas être retiré
sauf si toutes les connexions d’alimentation ont été
débranchées.
2
Rear Panel
Side Panel
3
Installation
