TROUBLESHOOTING
DISHWASHER
If you find a problem
when using your dishwas-
her, you will probably be
able to solve it by consul-
ting the following section.
When the dishwasher detects a malfunction, it will give you acoustic or visual warnings, depending
on the model.
On the top edge of the dishwasher door, there is a table to identify possible problems.
If this is not so, please
contact the
TECHNI-
CAL ASSISTANCE
SERVICE
and be ready
to provide as much infor-
mation as possible.
1
TECHNICAL OR FUNCTIONAL PROBLEMS
Models with a
display.
These models
identify the fault with the
letter ‘F’ followed by a
number from 1 to 9.
Models without
a display.
When there
is a malfunction, the dis-
hwasher gives off a series
of beeps, which stop for
seven seconds and then
start up again. You can
identify the malfunction
by counting the beeps (1
beep - door open; 2
beeps – no water at inlet;
and so on).
MALFUNCTION
Close the door
F1
1
MODEL
WITH
DISPLAY
NUMBER
OF BEEPS
MODEL
WITHOUT
DISPLAY
Not entering
F2
2
Not leaking
F3
3
Flood
F4
4
Over heating
F5
5
Not heating
F6
6
Tem. no detect
F7
7
No pressure
F8
8
Not even
F9
9
( F 1 )
1
To stop the beeps, press
the Start/Pause button.
Depending on the type of
malfunction, contact the
technical service about
the problem.
