2
edenox.com
English
edenox.com
COOLING SYSTEM:
The
tray
is
equipped
with
a
ventilated
evaporator,
which
can
be
accessed
for
cleaning
purposes
and
repairs
by
opening
the
hinged
lids
which
cover
the
same.
The
main
components
of
the
condensing
unit
include
a
hermetic
compressor
and
an
air
condenser.
The
gas
used
in
the
cooling
circuit
is
R507
(CFC
‐
free),
with
a
working
pressure
of
approximately
2
and
2.4
bar
depending
on
the
model.
The
gas
expansion
at
the
entrance
of
the
evaporator
is
carried
out
by
means
of
a
capillary
tube.
The
cooling
of
the
display
cabinet
is
carried
out
by
means
of
a
cold
air
flow
from
the
evaporator
through
the
holes
in
the
inner
doors
(model
with
doors)
or
in
the
back
(wall
mounted
model).
3. INSTALLATION AND START-UP
The in-situ installation and start-up of this appliance must be carried out by qualified technical
personnel.
Avoid having direct sources of heat, cold, humidity, sunlight and ultraviolet rays in the final location of
this appliance. Heaters, radiators, air conditioning, etc. can have a negative influence on the correct
operation of the same.
Check that the voltage and frequency of the electricity supply network coincide with those described in
the characteristics plaque. It is essential that the electricity installation where the appliance is to be
installed has an earth connection, as well as the necessary protection of a thermal magnetic switch and
a circuit breaker. Do not connect other appliances in the same electric socket.
Make sure that the appliance has adequate ventilation. Do not block the ventilation grid of the
condensing unit.
Remove the outside plastic and any remaining adhesive covering the steel
Once the panel or tray has been fitted into the hole in the furniture destined for this purpose, the
anchoring is carried out by means of the anchoring supplied as shown in Figure 2.
The
control
box
located
on
the
lower
part
of
the
appliance
can
easily
be
moved
to
the
side
of
the
technical
cabinet
if
required
(for
example
in
the
case
of
having
the
front
access
of
the
appliance
closed
due
construction
reasons
of
the
furniture
housing
it).
At
the
same
time,
it
can
be
removed
from
its
technical
cabinet
and
installed
in
any
other
panel
(for
example,
at
the
buffet
front
in
order
to
operate
and
regulate
the
appliance
without
having
to
open
the
door).
The
drainage
from
the
technical
cabinet
collects
the
liquid
that
may
have
been
accidentally
spilled,
and
the
evaporator
defrosting
water
which
on
occasions
and
depending
on
the
climate
can
be
considerable.
Therefore,
it
is
essential
to
connect
said
outlet
to
the
drainage
network.
The
present
appliance
does
not
have
a
collection
tray
and
automatic
evaporation
of
said
liquid.
Содержание VCRA-CV-CT
Страница 2: ...ii edenox com ELECTRIC DIAGRAM...
