Eden Halls Greenhouses Silverline 106 Lean-To, Руководство пользователя

Страница: 2 / 25

Introduction
You now own a greenhouse that is believed to be amongst the best in value on the market, and by carefully
following these assembly instructions, it will give you years of trouble-free use. We hope you will find the following
hints and explanations useful.
Your greenhouse is made of aluminium because it is the best all-round material within the price limits the average
householder can afford. It will not swell, shrink, warp or rust. In service, it should become a dull whitish-grey colour,
sometimes with a slightly rough surface on the outside which forms a self-protecting layer.
If you have the horticultural glass, the small panes are less likely to crack due to movement of the greenhouse, are
easier to transport and cheaper to replace in the event of accidental damage.
The acrylic sheet has been selected for its flexibility to form the curved part of the roof, its weather resistance and
lasting clarity.
We recommend that you give your greenhouse all round protection by including it in your house insurance.
Maintenance
To keep your greenhouse clean, occasionally wash the glass and aluminium frame thoroughly with a mild detergent
solution. For difficult stains, white spirit may be used.
The acrylic may be cleaned using warm soapy water applied with a soft cloth. If this does not remove foreign matter
then paraffin or white spirit may be used. Take care not to use any abrasive material that may scratch the acrylic.
Selecting a Site
Choose a sunny spot for your greenhouse where it will receive a fair amount of sunlight.
Note that the ridge height of your greenhouse with out the base is 2350mm.
Tools Required
1 – Screwdriver
1 – Spanner 10mm Across Flats
1 – No. 10 Masonry Bit and Drill
1 – Knife
1 – Spoon
1 – Pair of Pliers
1 – Spirit Level
Important
Before starting the assembly of your greenhouse, please check all the contents against the parts list. The parts for
each section are bundled together, so to avoid mixing them up, open each bundle separately. If anything is missing,
please contact Customer Service Dept., using the reply form included in these instructions.
1. Carefully read these instructions before unpacking and do not start to assemble until you fully understand
them.
2. Assistance will be necessary during assembly.
3. Considerable care should be taken in the preparation of a level and square base.
4. Before fixing frame to base, check for squareness and tighten all nuts and bolts. Weatherseal the join
between frame and base, frame and house and all other corner joints.
5. Glazing should not be hurried, but completed in one go, giving great care and attention to sealing the joints
between roof and panes with the sealant provided.
6. To minimise the condensation, we recommend that your greenhouse is well ventilated. This can be achieved
by the installation of a louvre vent. A louvre vent can only be fitted in the 106 and the 126 models.
7. It is recommended that a snow guard be fitted to the house gutter above the greenhouse if there is a risk
of falling debris damaging the green house.
1