©2014 Edelbrock LLC
Brochure #63-61169
Catalog #61169, 61175, 61179, 61189
Rev. 11/13/14 - QT
Page 2 of 2
is an issue. Stop the process, assess the problem and try again. If
spark plug tubes install successfully, remove the tubes and install the
valve cover. Following valve cover installation, insert the spark plug
tube using the OE O-ring for the spark plug tube seal at the valve cover
interface (not included with heads).
NOTE:
The use of these lower spark plug tube O-rings is not
required. Simply remove and discard if not using.
INSTALLATION:
Installation is the same as for original equipment
cylinder heads. Consult service manual for specific procedures, if
necessary. Be sure that the surface of the block and the surface of the
head are thoroughly cleaned to remove any oily film before installation.
Use alcohol or lacquer thinner on a lint-free rag to clean. Apply oil or
suitable thread lubricant to head bolt threads and the underside of
bolt heads and washers. Torque cylinder head bolts in three steps
following the factory tightening sequence
(See Figure 1)
.
Edelbrock LLC • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628
Fig. 1 - Cylinder Head Bolt Tightening Sequence
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Victor Jr. Cylinder Head Bolt Torque Spec
(Torque specs below only apply if using ARP Ultra-Torque Fastener Assembly
Lubricant; included with head ARP head bolt kits. If using other fastener
lubricant(s), please use manufacturer’s recommended torque specs.)
First Pass:
Torque all bolts, in sequence, to 25 ft./lbs.
Second Pass:
Torque all bolts, in sequence, to 40 ft./lbs.
Final Pass:
Torque all bolts, in sequence, to 80 ft./lbs..
NOTES:
A head bolt re-torque is recommended after initial start-up
and cool-down (allow 2-3 hours for adequate cooling).
Exhaust Side
SPECIFICATIONS:
Head Bolt Torque:
See Figure 1, or use head bolt
manufacturer’s specifications
Deck Thickness:
5/8”
Combustion Chamber Volume: 170 cc
Valve Size (Except for 61169):
Intake - 2.320”
Exhaust - 1.940”
Valve Seats:
Hardened ductile iron, non-
interlocking, compatible with
unleaded fuel
Valve Spring Diameter:
1.540”
Valve Spring Installed Height:
1.880”
Valve Spring Seat Pressure:
Hydraulic Roller Cam 151 lbs. @ 1.880”
Flat Tappet Cam 133 lbs. @ 1.880”
Valve Spring Open Pressure
Hydraulic Roller Cam 414 lbs. @ .600” Lift
Flat Tappet Cam 349 lbs. @ .600” Lift
Max. Valve Lift:
.700”
Coil Bind
1.120”
Replacement Valve Springs:
#5821 - Hydraulic Roller Cam
#5792 - Flat Tappet Cam