©2012 Edelbrock LLC
Part #1596, 1597, 1598, 1599
Brochure #63-1598
Rev. A - 2/12 - CP/mc
Edelbrock E-Force Supercharger System for
the 2010-2012 Camaro SS
Installation Instructions
Page 8
•
Use directional pad to highlight Return To Stock option
and press Select button.
•
Follow the on screen instructions.
Turn the car off when prompted to do so by the handheld
programmer.
•
Read parting message from programmer then press
Select to continue.
•
Unplug the programmer cable from the OBD-II port.
•
When you are ready to Install the supercharger, proceed
with Step 1 and you will be prompted to re-flash the ECU
towards the end of the installation procedure.
Supercharger Installation
1. Open trunk and lift trunk liner to access plastic hold
down. Unscrew plastic hold down then remove air
compressor and foam support.
2. Use a 10mm socket to loosen and remove the negative
battery terminal.
3. Lift the protective cover then use a 10mm socket to
loosen and remove the positive battery
terminal
4. Lift and support the front end of the vehicle using a
service lift or jack and appropriately load rated jack
stands then loosen and remove the lug nuts from both
front wheels. Remove the wheels and set them aside.
5. Use a T20 Torx wrench to remove the three bolts on
each side holding the front and the two holding the rear of
the front wheel fender liners. Use a panel puller to
remove the five body pins on each side that retain the
inner fender wells then remove them and set them aside.
6. Reach in through the wheel wells with a 10mm socket
to remove the four bolts at the front of each side of the
fascia then use a 7mm socket to remove the two bolts on
each side of the front fascia.
7. Disconnect the fog lamp electrical connectors and the
fascia wiring harness connector on the passenger side.
