VT100 Vertical Crawler™
Document: UMAH000514.docm
Revision: A14
Created by: PJ
Date: 05 Dec 2019
3029669-A14
Source Location: C:\ePDM\ISLEng\products\ah-versatrax100\manuals\UMAH000514.docm
Page 11 of 28
User Ma
nual
Vehicle and Tether Connection
It is important that the tether be properly connected to the vehicle
– otherwise damage to the system may
result.
1. Connect the vehicle end of tether to the back of the integrated harness block. Visually line up the
key in the connector before mating. Fully screw down and hand-tighten the locking collar.
2. Secure the tow cable to the cable grip on the tether using the quick-link. Adjust the cable grip
position to maintain a small amount of slack tether regardless the direction the tether is pulled, as
illustrated below.
3. Verify all device whips from the harness block to their respective components are securely
connected, and the whips are free from damage.
4. Ensure any unused connectors are capped with dummy plugs to insulate and protect their
electrical contacts.
