Spectrum 90
™ Camera
Document: UMAD007298.docm
Revision: A10
Created by: KJB
Date: 27 Sep 2019
IPN: 3041348-A10
Source Location: C:\ePDM\ISLEng\products\ad-spectrum90\manuals\UMAD007298.docm
Page 8 of 19
User Ma
nual
•
There are no user serviceable parts inside. This product may be serviced only by qualified
technicians or trained personnel.
•
Edddyfi equipment is used in many varied environments from hot/dry to confined spaces to deep
underwater. Such diverse environment risks must be addressed by the operators who are trained
to work in such surroundings. As such, the operator is responsible to determine safe site setup
and appropriate personal protective equipment (PPE) for operation and maintenance of the
equipment.
•
Do not use the product or any component exposed to pressures higher than the rated working
pressure.
In addition, observe the following precautions when cleaning or servicing the Spectrum
90™ camera:
•
Do not operate the camera with a damaged connector or cable. Inspect connectors and cables
regularly for damage.
•
Call the Eddyfi Technologies service department for assistance or service if needed.
CAUTION:
Disconnecting the camera while the power is on can cause damage to
the camera. Disconnect the power source before servicing the product.
CAUTION:
Do not over-pressure the camera through the Schrader valve.
Applying pressure beyond 15 psi through the Schrader valve may cause the
camera to burst resulting in injury and equipment damage. When re-purging, use
a regulated, gauged supply and apply no more than
10 psi
pressure.
System Setup
Unpacking Components
The Spectrum 90™ camera is shipped in a rugged case or is installed on an integrated system.
Packaging is selected to protect the camera from damage during shipping or storage. Upon receiving
your system, check the case and contents for any damage that may have occurred during transport.
Should any of these components be missing or damaged, please notify your vendor. We suggest that
when the system is re-shipped or stored for any length of time, it should be re-packaged in its original
case or be put in a cardboard box encased in high-density foam. It is also strongly advised that the case
be placed in a cardboard box again for shipping purposes. This measure greatly reduces rough handling
and subsequent shipping damage.
CAUTION:
The Schrader cap installed on your camera is a proprietary cap
rated to 300 m (1000 ft) depth.
Do not install any other Schrader cap.
Doing
so may result in flooding and destruction of the camera or in personal injuries
from electrical shorts. Standard automotive style Schrader valve components
will be forced open below 40 m (130 ft) depth by the water pressure.