E-SPVAC-I-0419
Page 12
1-800-638-3326
• edcoinc.com • [email protected]
10
Questions?
Call Ruwac at (413) 532-4030 or e-mail us at [email protected]!
IV.
Inspection & Maintenance
SLURRY VAC INSTRUCTIONS:
ELECTRO MOTOR BRUSH INSPECTION
5
Carefully dislodge the
plastic motor cap via
the built-in hooks on
both sides of motor
brush.
(TIP: Dislodge
one side of a cap first
followed by the other.)
With a flathead
screwdriver, flip brush
tab upward. Use pliers
to then pull the brush
out by the tab.
If the brush is worn
down to a length of
0.25” or less, replace
the brush. To replace
or reinstall brush, hold
down internal spring
using the tool supplied
with brush.
While holding spring
down, push the brush
back in. Remove the
brush tool once the
brush is in.
Push the motor brush
in until it’s flush.
1
2
3
4
NOTE:
A motor brush should be replaced if its length is less than 0.25 inches.
ELECTRO MOTOR BRUSH INSPECTION
