21
20
Do not laminate with following things
Stage 1 : Film Installation
Film installation is the same as the stage 1 of hot laminating.
Only the film should be placed at the upper end of the film core. MICRONEX is only for the single side laminator.
Film should be passed by the sub-roller. (Refer to the film loading)
If you does not like that, it will cause a film crease.
Stage 2 : Rewinder Paper Pipe Installation
1. Insert the paper core into
the rewinder paper pipe
2. Insert the paper pipe shaft
into the rewinder paper
pipge.
3. And then insert another
paper pipe core.
4. It is a figure of rewinder
installation finished.
Heat Roller
Pull-Roller
Upper Film
Rewinder
Upper Sub-Roller
Film Loading
According to the laminating status, Temperature and Speed control is needed.
1. After Installing separator,
insert the paper to push
out.
2. It is the same as hot
laminating stage 2 of
sequence 2~6.
7. Rewind the film into the
rewinder paper pipe.
8. It is a readiness for ultra-
thin film laminating.
Stage 3. Readiness for laminating
Ultra-thin film necessarily should be used at the condition of bottom heat roller cooled down.
Stage 4 : Laminating
It is a same procedure just like the hot laminating stage 3.
When you handle the ultra-thin film, the caution to treat.
1. At the condition of no paper and roller stopping, roller pressure handle should be at the stand-by status.
2. On operating, necessarily use the cooling fan.
3. Below 80g paper is not separated.
Metal plate, Timber board,
Clothes
Credit card
Things to be tarnished
easily by heat
Combustible things
After laminating paper printed by heat transfer printer, as time goes by, the paper may
be tarnished.
In the case of film width is above 1M or 25KG, More than 2persons is needed.
If you does not, you can suffer a personal injury.
Using a separator, separate the laminated Film
and paper.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
