19
18
Stage 1 : Film Installation
1. Insert the film into film
core.
2. After film sheaft insertion,
lock it with fixing bolt.
3. After another film core
insertion, lock it with fixing bolt.
4. Reitherate sequence 1~3,
ready for another set.
When you exchange the film, first pull out the fixing
ring and take off it. After fixing ring thaking off, push
film shaft at the other direction, you can change it.
Fixing ring
Film fixing ring
Fixing core bolt
In the case of film width is above 1M or 25KG, More than 2persons is needed.
If you does not, you can suffer a personal injury.
Upper Film
Bottom Film
Pull Roller
Heat Roller
Upper Sub-Roller
Stretch Bar
Bottom Sub-Roller
Film Loading
At the condition of laminating status, temperature and speed adjusting is needed.
Stage 2 : Laminating Readiness
1. The edge of upper film should be
positioned at the upper roller.
2. The inserted paper between rollers,
should be sticked to upper film.
3. Bottom film should be sticked to
paper and bottom film.
4. Install the feed table.
5. Install the safety cover.
6. Install the pressure plate.
It is easy to work if you preheat the roller before readiness stage.
Necessarily film should be passed by sub-roller. (Refer to film loading)
If the film does not pass by sub-roller, it will cause a film crease.
Film tension is available to adjust according to the laminating results,
basically film tension is enough to spread over the film crease.
When paper width is smaller than the laminating film, the glue of film can contaminate the bottom roller.
It is possible to use the paper width larger than film width.
At the condition of roller stop, lay down the roller pressure handle to the preheating or stand-by. It is for preventing roller
damage.
Be cautious to the body touch to the heat plate at laminating.
It will cause a personal damage.
When you laminate and machine running, you shoud be careful not to touch
the hair,necktie, necklace with the machine. It will cause a personal injury.
1. Set the pressure control handle to
the right position.
2. Set the right speed and temp.
3. Load the paper on the feeding table
and insert the paper slightly.
Stage 3 : Laminating
Film Core
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
