9
EN
ruckus
®
MaIntenance
electronIc sPeed control (esc)
Programming:
The ESC comes with two jumpers pre-installed
in the REV: ON and BATT: Ni-MH configurations.
To disable reverse or change battery type to Li-Po, disconnect the
jumper from the default port and connect it to the desired port.
Power off the ESC, then power it back on.
If the jumpers are lost or not installed, the ESC will default
to REV: ON and BATT: Li-Po.
electrIcal layout
For correct operation, Channels 1 and 2
must be used as shown in the wiring diagram.
The motor can be disconnected from the ESC
at the connectors in the wiring.
Part #
Description
A
DYNS1215
Motor
B
DYN1072EC
Battery 8.4V
C
SPMSS6170
Waterproof
Steering Servo
D
SPMSR201
Waterproof Receiver
E
DYNS2210
Waterproof Electronic
Speed Control (ESC)
F
Channel 1
G
Channel 2
Operation
LED Status
Sound at Power UP
Stop
OFF
Forward
Blinks
Forward (full speed)
Solid
Reverse
Blinks
Brake
Blinks
Brake (full brake)
Solid
Ni-MH/Ni-Cd Battery
1 Short Beep
2S Li-Po Battery
2 Short Beeps
ESC Ready
1 Long Beep
Battery Low Voltage
Blinks
Overheat
Blinks
EC3
EC3
a
B
c
d
e
g
f
LED