11
en
circuit
BIndIng
failsafe
In the unlikely event the radio connection is lost during use, the
receiver will reduce the throttle to idle. The steering channel holds the
last input command. If you power on the receiver before powering on
the transmitter, the receiver enters failsafe mode with throttle at idle.
When you power on the transmitter, normal control resumes.
Binding is the process of programming the receiver to recognize the
GUID (Globally Unique Identifier) code of a single specific transmitter.
The included transmitter and receiver are bound at the factory. If you
need to rebind, follow the instructions below.
1. Power off the transmitter and ESC.
2. Connect a fully charged battery pack to the ESC.
3. Power on the ESC.
4. Remove the front cover. Press the bind button (
a
) on the receiver.
The RED LED on the receiver flashes rapidly.
5. Power on the transmitter.
6. The RED LED on the receiver turns solid when the system is bound.
Replace the front cover.
You must rebind when you want to use a different transmitter.
No. Description
TAPPING BINDER HEAD M3x10mm
TAPPING BINDER HEAD M3x12mm
TAPPING FLAT HEAD M3x15mm
TAPPING FLAT HEAD M3x12mm
TAPPING FLAT HEAD M3x10mm
TAPPING BINDER HEAD M3x18mm
TAPPING FLAT HEAD M2x16mm
TAPPING BINDER HEAD M3x16mm
WASHER 5x7x0.5mm
E-CLIP E2.5
LOCK WASHER
FLANGED LOCK NUT M4
WASHER 3x8x0.5mm
LOCK NUT M3
WASHER 2x7x0.5mm
SET SHAFT SCREW M3x13mm
No. Description
BUTTON HEX M2.5x4mm
SETSCREW M3x3mm
SETSCREW M3x12mm
STEP SCREW M3x0.5x13.4mm
STEP SCREW M3x0.5x10.5mm
BUTTON HEX M2.5x8mm
STEP SCREW M3x0.5x7.4mm
BINDER HEAD M3x8mm
BINDER HEAD M3x12mm
BINDER HEAD M3x20mm
BINDER HEAD M3x25mm
BUTTON HEAD M3x30mm
BUTTON HEAD M2x6mm
TAPPING BUTTON HEAD M3x10mm
No. Description
fasteners
a
