6
EN
1.
Power on the transmitter.
3.
Perform a test of the transmitter’s control of the vehicle
with the vehicle’s wheels off the ground.
4.
Start driving slowly, and, if the vehicle does not go straight,
adjust the steering trim dial on the transmitter.
IMPORTANT:
Seat the motor brushes by driving smoothly on a flat
surface during use of the first battery charge. Properly seating the motor
brushes will increase the life and performance of the motor.
2.
Connect the battery to the Electronic Speed Control
(ESC) / Receiver unit and power on the vehicle .
BINDING
The included transmitter and receiver are bound at the factory. If you
need to rebind, follow the instructions below.
1.
Power off the transmitter and ESC.
2.
Connect a fully charged battery pack to the ESC.
3.
Power on the ESC. The RED LED on the receiver flashes.
4.
Press and release the bind button
(A)
on the receiver.
The RED LED on the receiver flashes rapidly.
5.
Power on the transmitter.
6.
The RED LED on the receiver turns solid when the radio system is
bound.
You must rebind when binding the receiver to a different transmitter.
NOTICE:
Do not attempt to bind the transmitter and receiver if
there are other compatible transmitters in bind mode within 400
feet. Doing so may result in unexpected binding.
A
GETTING STARTED