5
EN
INSTALLING THE BATTERY
1.
Remove the vehicle body.
2.
Install a fully charged battery.
3.
Secure the battery pack using the hook and loop straps.
4.
Connect the battery pack to the ESC power connector.
CAUTION:
Connecting the battery to the ESC with reversed polarity
will cause damage to the ESC, the battery or both. Damage caused by
incorrectly connecting the battery is not covered under warranty.
TRANSMITTER CONTROLS
BATTERY LEVEL INDICATOR
Solid Red and Green:
Battery voltage is good
(above 4V).
Solid Red:
Battery voltage
is critically low (below
4V). Replace transmitter
batteries.
POWER SWITCH
Power on or off the transmitter
STEERING WHEEL
Control steering.
Right and Left
steering
THROTTLE TRIGGER
Controls power to
the motor
for forward
or reverse
Stop
Adjusts the neutral point
of the electronic speed
control
THROTTLE TRIM
STEERING DUAL RATE
Adjusts the amount
the steering moves when
the steering wheel is turned
left or right
Adjust to make the
vehicle drive straight
with no input at the
steering wheel
STEERING TRIM
REVERSE SWITCH
Allows you to change the direction of steering (ST.
REV) and throttle (TH. REV) controls (Ensure proper
function with a radio system test).
THROTTLE DUAL RATE
Adjusts the maximum
amount of throttle the
vehicle can be given
Reverse
Forward
INSTALLING TRANSMITTER BATTERIES
CAUTION:
If using rechargeable batteries, charge only rechargeable batteries. Charging non-rechargeable batteries may cause the batteries to
burst, resulting in injury to persons and/or damage to property.
This transmitter requires 4 AA batteries.
1.
Remove the battery cover from the transmitter.
2.
Install the batteries as shown.
3.
Install the battery cover.
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to national regulations.
